Irangex irx4 plus 2.4g cc2500 nrf24l01 a7105 Frsky 4 in 1 Multiprotocol

Product Information Four-in-one multi-protocol tuner STM32 upgraded version This is a great multi protocol module for your FrSky ACCST or ACCESS transmitter and Turnigy 9XR and 9XR Pro.  This one multi protocol module will replace all of the different protocol 2.4Ghz Transmitter modules. Also works with most transmitters that have a JR module bay and can provide a PPM signal to the module.  The PPM firmware can be downloaded from github. This module has a USB port for easy firmware upgrades. Just download Flash Multi V0.6.1 from github and follow the setup instructions. These modules have been updated to firmware version V1.3.3.7 AETR or higher for use with OpenTx V2.3.9 or higher in serial mode. Works best with the latest firmware OpenTx V2.3.12. or higher. For best results with your Turnigy 9XR Pro you need to upgrade the ersky9x firmware to R223A6.  Just go to "erskyTx test versions" to download the firmware.  The latest module firmware V1.3.3.7 or higher works great with both of the latest versions of OpenTx and erskyTX. Manual and data download: http://pan.baidu.com/s/1bokfOjt Working parameters: Working voltage: 5-14 volts Working current: <=100mA Working frequency: 2.4G ISM band RF power: +22dBm Main control chip: STM32F103CBT6 (128K ROM, 20K RAM) Size: 55x41x7mm, without buttons Net weight: 23g, with antenna The tuner has two working modes: PPM mode and serial port mode. In PPM mode, there are 31 different protocols corresponding to the 16 positions of the rotary coding switch (protocol 0 is reserved for serial port mode). Please refer to the list on the previous page of the manual for the correspondence between the two. When the green light is off, you can use the knob to select protocols No. 1 to 15, and when the green light is on, you can select protocols No. 16 to 31. If you need to turn on or turn off the green light, please follow the steps below: Turn off the remote control, point the rotary coding switch to "0", press and hold the black link button on the tuner, then turn on the remote control, release the button after 3 seconds, and then you can see the green light switch between on and off , The optional protocol will be switched at the same time. In PPM mode, normal use operation: 1. Fix the tuner, install the antenna, and turn on the PPM signal output on the remote control 2. According to the following default protocol list and your receiver type, point the tuner knob (the end of the handle with the vertical groove) to the corresponding gear. 3. When the linking has been completed, turn on the power switch of the remote control, the red indicator light on the tuner will always be on, and then the tuner will start to work normally, and then turn on your receiver (or airplane). 4. The tuner cannot switch the protocol during normal use. If you need to switch the protocol, please turn off the power first, adjust the knob, select the desired protocol, and then power on again. 5. If there is no valid PPM signal input, the red light will flash slowly. In PPM mode, linking operation: 1. Turn on your receiver (or airplane) and follow the instructions of the receiver to enter the linking mode. 2. Press and hold the black link button on the tuner, turn on the remote control and wait to enter the system interface. After 3 seconds, release the link button, you can see the red indicator flashes quickly, indicating that the tuner enters the link mode. When the linking is over, the red light is always on. 3. Some protocols (for example: S-FHSS) do not need to operate on the tuner for linking, and for some protocols (for example: hubsan, e010), the tuner will automatically link to the frequency as soon as the tuner is turned on. . Operation in serial mode: When the green light is off and the knob on the tuner points to "0", the tuner can enter the serial port mode. In the serial port mode, all existing protocols can be used. The tuner protocol switching and frequency-linking operations can be done through the remote control. The menu is implemented, but only the remote control using er9X/erSky9X or OpenTX open source firmware can use the serial port mode. In addition, your remote control firmware also needs to be upgraded to the latest version. For related information, see: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module About the tuner firmware upgrade: There are two jumper caps attached, do not short-circuit it in normal use, and short-circuit it according to the situation when upgrading the firmware. The tuner can upgrade the firmware in two ways, a USB serial cable or a Micro USB cable (that is, a common Android phone data cable). The USB serial port method is relatively simple, so some general users recommend to equip it with a USB serial cable to upgrade. For related information, see: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/blob/master/docs/Compiling_STM32.md Terms and Condition Payment - We only accept payments via PayPal. - Payment must be received within 7 days after the end of the action Shipping - Shipping Location: We ship to Worldwide. Item will be shipped to the PayPal shipping address if no special notes from buyer. - Shipping Method: Items will be shipped out within 1-2 business days** by Standard Air-Mail after receiving full Payment. - Registered Mail Service: We also offer REGISTERED MAIL service for buyer, the additional cost per package is US$2. Tracking number will be provided for registered mail only. For the order amount is over US$15, the registered mail fee could be waived. - To Ship to United States, all shipping fee is included the registered airmail service. Estimated Shipping Time For USA/ Canada / United Kingdom / Australia / Germany: 8 -15 business days** For Spain / France / Netherlands / Belgium / Austria: 15 - 25 business days** For Italy / Brazil/ Other Countries: 20 - 40 business days** If you can't offer this patience, please Do Not Buy! Or please choose Express delivery at higher postage fee! - Please email us for cost details when you would like express service for faster delivery. **The business day is not included weekends and public holidays. Shipping Discount on multiple purchased - We always combine Postage and provide 10% discount for the shipping fee of items or above. After you buy 2 items or above, please inform us your ebay account name and we will send an invoice with shipping discount to you ASAP, then you could pay easily and exactly. Return Policy - All products have been checked and packaged in good condition before dispatch. - We provide 30 days return policy, calculated from the date we shipped the item to you. For any reasons you are not satisfied, please return the item to us in its original condition for a refund or an exchange. Buyers have to pay for the return cost and we will pay the cost for resend. - Before mailing us back the item, please contact us via email or eBay system so that we could provide you the detailed return and exchange instruction. Contact Us - If you have any questions, it is welcomed to contact us via eBay system. We always reply you within 48-hour. -  We have always been trying to provide the best service and reliable products for every customer. Please feel free to contact us to resolve any issue before leaving negative feedback.
Powered by SoldEazy

Returns Accepted for this item if it's within 30 Days